Adding warmth with control and consistency

By · · 9 min read

Adding warmth with control and consistency

  

Adding warmth with control and consistency

Do your recordings have warmth? Yes? But does the amount of warmth vary with the signal level? Wouldn’t you like it to be more consistent…

By David Mellor, Course Director of Audio Masterclass

It is widely known that the right kind of distortion can give a recording the subjective quality of ‘warmth’. A single-ended tube stage of amplification, which will of course naturally be Class A, will give you plenty of those lovely even-order harmonics - the ones the ear likes.

But the problem is that the amount of ‘warmth’, or distortion to use the proper term, depends on the level of the signal. The louder the signal, the more distortion.

But what if you want a little more warmth in the low-level subtle sections of your playing? What do you do?

One answer might be to compress the signal so that it is pretty much all of the same level, then the degree of warmth will be consistent. But then you have lost those low-level subtleties. Can we do better?

Yes we can. Split the signal into two so that one feed goes straight through and the other to the compressor, and then to the ‘warmth generator’. Now mix the compressed and warmed up signal with the ‘dry’ signal. The result is consistent and controllable warmth. Just mix in as much as you need.

As a final touch, you can also try cutting the bass from the signal before the compressor and warmth generator. The advantage of this is that low frequencies tend to produce harsher distortion than mid and high frequencies, where the distortion is smoother. In fact, you could probably cut as high as 500 Hz with benefit.

No more cold winter nights!

(Or you could buy an Aphex Aural Exciter.)

Publication date: Saturday August 15, 2009
Author: David Mellor, Course Director of Audio Masterclass

Tweet


There is no discussion on this topic yet. You could be the first!

We welcome your addition to the discussion on the topic of this article. If you feel that the article is inaccurate in any way, please let us know by e-mail at [email protected]. We read all messages sent to this address but we cannot promise a reply.
 
You don’t need an account to post :-)

How can you get excellent vocal quality from a normal mic? An RP reader wishes to improve the sound he gets from his microphone. Is this possible, or does he need a better mic? Read more…

“The Teaser!” by Laids Cretins des Alpes The Album ‘MORTEL!’ (KILLER!) was written and composed essentially by the Dr Droopi since the end of the recordings sessions for the last album ‘keskonvafair?’… Read more…

Why your preamp should have an impedance selector. You’re missing out if it doesn’t… Some microphone and instrument preamplifiers have a variable impedance selector. What kind of difference will it make to your sound? What are you missing if you don’t have it? Read more…

Q: Will the preamp in my interface spoil the great sound of my mic pre? A RecordProducer.com reader has an expensive microphone preamplifier. But he worries that all is lost when he connects it to the preamp of his audio interface. Read more…

$8.70 for a single download? How on earth do they get away with those prices? A record label specializing in high quality audio charges $$$ for its tracks. But will you get good value for your money? Read more…

Why delay is good for you (and how to set delay times) ”) Delay is one of the simplest yet (currently) under-appreciated effects available. But how do you work out the correct settings? Read more…

Q: If I filter out low frequencies, can I get them back again later? I have heard that it’s good to filter out low frequencies on all but bass instruments. But what if I record everything like that and change my mind later? Read more…

The Roland V-Piano Grand - will it put Steinway out of business? Roland’s V-Piano mimics acoustic instruments with stunning realism. Will the new V-Piano Grand oust the conventional grand piano? Read more…

Q: Can I tell at a glance if my preamp is tube or transistor? Can you recognize by a glance what kind of amplifier you have in front of you without reading the specifications? Do they have special visual features? For instance, could I recognize a vacuum tube from a transistor one? Read more…

Q: You said you can’t play my audio, but I can play it fine. What gives? I sent you an audio file by email, but you wrote back and said you couldn’t play it. I can play it fine on my computer. Shouldn’t you be able to play any audio file? Read more…

Choosing equipment? Here’s how to make the right choice and not waste money. You can spend a lot of money on equipment. You can WASTE a lot of money on equipment too. Here’s how to simplify the decision-making process. Read more…

An amazing new ground-floor opportunity in production! It’s not often a genuinely new opportunity comes along, but one is about to very soon. Anyone can have a go at it. Those who succeed will hit the big time. Read more…

Q: Why does my mixer have a 48 volt switch? A RecordProducer.com reader wonders what the phantom power switch is for, and how it might improve the signal from the microphones. Read more…

How to make your recordings sound great in the car Sometimes recordings that are made in the studio just don’t sound like ‘real records’ when played in the car. How can you solve that? Read more…

Is it cheating to use Auto-Tune? The Auto-Tune debate is unlikely to go away. Those who can, sing. Those who can’t use Auto-Tune. Read more…

Q: Why do I hear a scratchy sound in my mixing? An RP reader sets us a challenge to answer his question in utter seriousness without any trace of inappropriate humor… Read more…

Comment of the week: Just how hard is it to ‘get into the groove’? A RecordProducer.com reader, like so many of us, finds it difficult to get into the groove. Is groove a lost art? Read more…

Microphones don’t matter David Mellor argues that knowing how to position a microphone can make a far bigger difference to the quality of your work than which microphone you choose. Read more…

If you use compression on stage, will your sound sparkle, or will unholy feedback ensue? The compressor is a great studio tool. But does it work for live sound? Is there a hidden danger that will keep the engineer on his toes? Read more…

Before you do anything else, get the tempo right Many people blunder into a new recording without giving tempo more than half a moment’s consideration. But setting the right tempo can make or break a track… Read more…

 

Related reading

Who we are

Full story

Record Producer is a dedicated platform for aspiring and established music producers, offering valuable insights, tips, and resources to elevate your craft.